Best current price£1.10from Professional Building Supplies
Shopping.co.uk recommended and popular offers
Professional Building Supplies£1.10Visit shop Floplast Men's Grey Solvent Weld Waste Bend Swivel And Fe - 90 Degree X 40Mm
Visit shop
The Range£5.23Visit shop Floplast Abs Solvent Weld 90° Conversion Bend 40Mm Grey - Ws27 - Perfect For Plumbing Applications - Grey
Visit shop9 offers from £1.10 - £7.76
View price history by clicking the chart icon.
This guide is for plumbers and DIY enthusiasts working with waste pipe systems. The FloPlast Solvent Weld 90 Degree Conversion Bend offers a robust and cost-effective solution for creating tight 90-degree turns in solvent weld waste pipes. Its primary caveat is that solvent weld joints are permanent and cannot be demounted once made, requiring careful installation. Key features include its durable ABS construction, 40mm diameter, clean gloss grey finish, and compliance with relevant British and European standards, ensuring reliable and aesthetically pleasing plumbing connections.
| Model Part Number | ABS WS27G |
|---|---|
| Brand | FloPlast |
A conversion bend, often called a swivel or M&F bend, is used to create a tight radius change of direction, typically 90 degrees, in a waste pipe system. It helps navigate tight spaces or connect pipes at specific angles.
No, solvent weld joints are permanent. Once the solvent cement has set, the joint cannot be demounted. Any incorrect joint will require cutting out the affected section and replacing it with new components.
This bend is specifically designed for solvent weld waste pipes made of ABS or similar solvent-weldable plastics.
The installed system should be left undisturbed for a minimum of 12 hours after making the solvent weld joints to allow them to fully cure and achieve maximum strength before testing or use.
This FloPlast solvent weld waste fitting is manufactured in the UK to BS EN 1455 and BS 5255 standards and is Kitemarked (KM 548614).
While ABS is durable, this specific fitting is intended for standard above-ground waste water systems. For underground applications, other specific drainage systems and materials may be required by local building regulations.
A 90-degree bend provides a direct right-angle turn. A 92.5-degree bend (often referred to as a ' 90-degree' bend in plumbing due to common interpretation) offers a slightly gentler curve, which can sometimes be beneficial for flow but might take up slightly more space. This product is specifically a 90-degree bend.
Ensure surfaces were clean and dry before applying solvent cement. The pipe may not have been fully inserted or twisted correctly. If the leak is minor and the joint is otherwise sound, a professional may be able to repair it, but often requires cutting out and rejoining.
Verify that the correct type of solvent cement for ABS pipes was used. Ensure the 12-hour curing time was observed before testing. Check that the components were held firmly for the initial 30 seconds after joining.
Check for any obstructions inside the fitting socket or on the pipe end. Ensure the pipe is cut square and deburred. Lightly score the pipe end if necessary, but avoid over-sanding which can damage the surface.
Compatibility:
This fitting is designed exclusively for solvent weld waste pipes and is not compatible with push-fit or compression fittings.
**Installation Steps (Solvent Weld Joint):
**
Important Safety Note: Always work in a well-ventilated area when using solvent cement. Keep the cement away from heat sources and naked flames. Avoid skin contact; if it occurs, wash immediately with soap and water.
Care:
This fitting requires no specific ongoing maintenance beyond ensuring the connected waste system is clear of blockages. The ABS material is inherently resistant to corrosion and most household chemicals.
