Best current price£23.95from eBay
Shopping.co.uk recommended and popular offers
eBay£23.95Visit shop UPOL SYSTEM 20 PLASTIC PRIMER ADHESION PROMOTER 1 Litre S2003/1
Visit shopeBay£23.95Visit shop 1x UPOL SYSTEM 20 PLASTIC PRIMER ADHESION PROMOTER 1 Litre S2003/1
Visit shop6 offers from £23.95 - £64.95
View price history by clicking the chart icon.
The U-POL System 20 Plastic Primer (S2003/1) is an ideal solution for professional automotive body shop technicians and serious DIY enthusiasts looking to ensure a long-lasting, professional-grade finish on plastic components like bumpers. Its primary benefit is providing superior adhesion for subsequent paint layers, which effectively prevents the common issues of peeling or flaking over time. While it is a highly effective, ready-to-use product, users should note that it requires proper surface preparation and a clean environment to achieve optimal results, as it cannot compensate for poorly cleaned or damaged plastic surfaces.
| Model Part Number | S2003/1 |
|---|---|
| Brand | U-pol |
No, the U-POL System 20 Plastic Primer is a ready-for-use formula and should not be thinned.
No, this product is specifically formulated for plastic surfaces and will not provide the required adhesion for metal.
Yes, a light abrasion with fine-grade sandpaper or a scouring pad is necessary to provide a mechanical key for the primer.
Typically, one light, uniform coat is sufficient to promote adhesion for subsequent paint layers.
It is compatible with most standard automotive paint systems, but it is always best practice to test on a small, inconspicuous area if unsure.
Due to its fast-drying nature, you can usually apply your primer surfacer or topcoat within 15 to 30 minutes, depending on local temperature and humidity.
Usually caused by improper surface cleaning; ensure all mold release agents were fully removed with a dedicated plastic cleaner.
Ensure the spray gun is adjusted correctly and that the primer is applied in thin, light coats rather than one heavy, wet application.
Check the ambient temperature; low temperatures or high humidity can significantly impede solvent evaporation.
To use, ensure the plastic surface is thoroughly cleaned with a plastic degreaser to remove mold release agents, wax, or silicone. Lightly abrade the surface using a fine-grade abrasive pad (P600-P800) to create a mechanical key. Shake the container well before use. The product is best applied using a standard spray gun setup. Store the container in a cool, dry place, ensuring the lid is sealed tightly to prevent evaporation. Avoid applying in temperatures below 15°C (60°F) to ensure proper flow and drying characteristics.
