Air Finger Belt Sander - 20mm

You will need an air compressor that can consistently provide 90 PSI with an average air consumption of 4 CFM. It is recommended to have a compressor that can supply at least 6 CFM for optimal performance.

The sander uses 520mm long by 20mm wide sanding belts. Three such belts are included to get you started.

The sander's high RPM and belt system are suitable for both material removal and polishing, depending on the grit of the sanding belt used. It's particularly effective for contouring and finishing in hard-to-reach areas.

Typically, there is a tensioning lever on the sander that you would release to loosen the belt, remove the old one, install the new belt, and then re-engage the lever to tension it. Consult the manual for precise instructions.

Yes, it can be used for various automotive tasks like polishing metal parts, cleaning welds, or preparing surfaces in tight engine bay areas.

Please refer to the product packaging or AB Tools official website for specific warranty information, as it can vary.

Check air pressure to ensure it is at 90 PSI. Verify the air line connection is secure and there are no leaks. Ensure the air compressor is meeting the recommended 6 CFM. Check if the belt is jammed or excessively tight.

Ensure the sanding belt is correctly installed and not damaged. Check for any debris lodged in the belt or rollers. If vibration persists, inspect the tool for internal damage.

Refer to the tool's specific instructions for belt replacement. Usually, there is a tensioning lever or mechanism that needs to be engaged to release or apply tension to the belt.

Inspect all air line connections for tightness. If leaks are coming from the tool's housing, it may indicate a seal failure and require professional inspection.