Solder Ring Elbow - 90 Degree x 22mm - Primaflow

They feature integrated solder, meaning you don't need to add separate solder during installation, saving time and effort.

Yes, PrimaPlus Solder Ring fittings can be used for gas installations, provided all relevant safety standards and local regulations are followed.

They are manufactured to EN 1254 standard, are WRAS approved for drinking water, and carry Kite Mark approval to BS standards.

You will need standard plumbing tools including a pipe cutter, deburring tool, flux, a blowtorch for soldering, and appropriate safety gear.

Proper cleaning of the pipe and fitting, correct application of flux, even heating of the joint, and allowing it to cool undisturbed are crucial for a strong joint.

These fittings are designed for standard domestic water and gas pressures. Always consult system specifications and local codes for high-pressure applications.

Ensure the pipe and fitting were thoroughly cleaned and fluxed. Reheat the joint evenly and ensure the solder fully penetrates the gap. Check for excessive solder or contamination.

Verify that the fitting and pipe are heated to the correct temperature for the integrated solder to melt. Ensure sufficient flux has been applied. Avoid overheating, which can burn off flux.

Slight discoloration is normal due to heat. If the discoloration is severe or indicates burning, you may have overheated the fitting. Ensure proper technique and ventilation.