Floor Cover Trim Door Bar Threshold - Self Adhesive - FloorPro
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later.
Product Information
Full details
This FloorPro Floor Cover Trim Door Bar Threshold is designed for homeowners and DIY enthusiasts looking to create a seamless transition between different hard flooring types, such as laminate, wood, or LVT, especially at doorways. Its key benefit is providing a neat, professional finish by covering gaps up to 37mm with an easy peel-and-stick application. A potential caveat is that it is best suited for joining floors of the same height and may not be ideal for significant height differences.
All features
| Brand | FloorPro |
|---|
Extended Product Information
FAQs
What types of flooring can this be used with?
This threshold is designed for use with hard flooring such as laminate, wood (engineered and solid), and Luxury Vinyl Tile (LVT).
How wide a gap can this threshold cover?
The threshold can cover gaps up to 37mm (approximately 1.46 inches) wide.
Do I need any special tools to install this?
No, installation is a simple peel-and-stick process. You may need a saw if you need to cut it to a specific length.
Can this be used for different floor heights?
It is best suited for joining floors of the same or very similar heights. Significant height differences may require a different type of transition strip.
How long is the threshold bar?
The threshold bar comes in a standard length of 3ft (0.9 metres).
What is the total width of the threshold?
The total width of the threshold bar is 37mm.
How should I clean the threshold?
You can clean it with a damp cloth and mild detergent. Avoid using abrasive cleaners or excessive water.
Troubleshooting
Threshold not sticking firmly
Ensure the subfloor is completely clean, dry, and smooth before application. Re-ensure firm, even pressure is applied during installation.
Gap is slightly wider than 37mm
This threshold is designed for gaps up to 37mm. For wider gaps, consider alternative solutions or professional advice.
Difficulty cutting to size
Use a fine-tooth saw and measure precisely. Consider practicing on a scrap piece first. Ensure the cut edge is clean and smooth before installation.
Adhesive lost effectiveness after repositioning
The self-adhesive is designed for a single application. If repositioning is needed, consider using a compatible flooring adhesive for a secure bond.
Pros and Cons
Pros
- Extremely easy to install with no special tools required.
- Provides a clean and professional look to floor transitions.
- Covers unsightly gaps effectively.
- Suitable for a variety of hard flooring types.
- Quick and efficient solution for finishing flooring projects.
Cons
- Best suited for joining floors of the same height; may not accommodate significant height differences.
- Adhesive may not adhere well to uneven or unclean subfloors.
- Limited to a fixed width of 37mm.
- May require cutting for custom lengths, which needs careful measurement and execution.
Setup, Compatibility & Care
Setup:
- Ensure the subfloor at the transition point is clean, dry, and free from dust, grease, or debris.
- Measure the gap accurately. If needed, cut the threshold to the desired length using a fine-tooth saw, ensuring a straight cut.
- Carefully peel the protective backing from the self-adhesive strip.
- Position the threshold bar over the gap, aligning it with the edges of your flooring.
- Press down firmly along the entire length of the bar to ensure a secure bond. Apply even pressure for at least 30 seconds.
Compatibility:
- Compatible with hard flooring types including laminate, engineered wood, solid wood, and Luxury Vinyl Tile (LVT).
- Designed for joining floors of equal or very similar height.
- Suitable for gaps up to 37mm wide.
Care:
- Clean with a damp cloth and mild detergent if necessary. Avoid abrasive cleaners or excessive moisture.
- Regularly check the adhesion, especially in high-traffic areas, and reapply pressure if needed.