Tetrosyl Trade Spray Paint - White - 500ml

This primer is suitable for a wide range of automotive surfaces including rigid plastics, metal, and existing paintwork. It is also effective on wheels and wheel trims.

The paint is fast-drying. Typically, it is touch-dry within minutes and ready for recoating after approximately 15-30 minutes, depending on temperature and humidity.

While compatible with cellulose finish paints, for best results and to ensure optimal adhesion and finish, it is recommended to use Tetrosyl topcoats. Always test on an inconspicuous area first if using a different brand.

Ensure the can is shaken thoroughly, hold it at the recommended distance (25-30 cm), and apply in light, even, overlapping coats using the adjustable nozzle. Avoid applying too heavily in one go.

Coverage varies depending on the application thickness and surface porosity, but a 500ml can typically covers approximately 1-2 square meters with two coats.

This primer is formulated for rigid plastics. For flexible plastics, it is advisable to use a primer specifically designed for flexible substrates.

Store the can in a cool, dry place away from direct sunlight, heat, and open flames. Ensure the nozzle is cleared after each use and the cap is replaced securely.

Shake the can more thoroughly. Ensure the nozzle is not blocked. Clean the nozzle by inverting the can and spraying for a few seconds. Hold the can at the correct distance (25-30 cm).

Apply in lighter, more even coats. Reduce the amount of paint applied per pass. Ensure the can is held at a consistent distance and angle.

Ensure the surface is clean, dry, and free from grease, oil, or wax. Lightly abrade the surface if necessary. Always perform a test spray on a small, hidden area first.

Immediately after spraying, invert the can and spray for 5-10 seconds to clear the propellant and prevent clogging. If still clogged, remove the nozzle and soak in a suitable solvent like cellulose thinners, then rinse and dry before reattaching.