B2C Brass Hosetails Barb-Bsp Male Thread Joiner Air Gas Water Fuel Hose Tails - 1/2"bspm - 13mm Barb

It means the hosetail has a 1/2 inch British Standard Pipe male thread on one end and a 13 millimeter barb fitting on the other end, designed for connecting a hose of approximately 13mm internal diameter.

It is suitable for air, water, and most common fuels. For specific chemical compatibility, consult a relevant chart or manufacturer's guidelines.

It is recommended to use PTFE (thread seal tape) or a suitable pipe sealant on the male BSP thread for a secure, leak-free connection.

You should use a hose clamp sized appropriately for a 13mm barb fitting to ensure a tight and secure grip on the hose.

It can be used for moderate pressure air lines. For very high-pressure applications, always ensure the entire system, including the hosetail, hose, and clamps, is rated for the operating pressure and meets safety standards.

No, this specific hosetail is designed exclusively for 1/2" BSP male threads. Using it with other thread sizes will not create a proper seal and may cause damage.

Clean with a soft cloth and mild soap if necessary. Avoid abrasive cleaners or solvents that could damage the brass finish.

Ensure the 1/2" BSP female fitting is clean and undamaged. Reapply thread sealant tape if necessary and tighten the connection securely but without overtightening.

Verify the hose's internal diameter matches the 13mm barb. Ensure the hose is fully seated onto the barb and the hose clamp is tightened sufficiently.

Check that both the male thread on the hosetail and the female fitting are clean and free from debris. Ensure you are using the correct BSP thread size and the fitting is aligned properly to avoid cross-threading.

While brass is corrosion-resistant, prolonged exposure to harsh chemicals or moisture can cause surface oxidation. Clean with a soft cloth. For ongoing use in corrosive environments, consider brass fittings specifically rated for such conditions.