Phoenix Contact M8 Sensor Actuator Cable - 4 Way - Unterminated

An IP67 rating means the connector is dust-tight and protected against immersion in water up to 1 meter for 30 minutes. This makes it suitable for demanding industrial environments.

Yes, you can cut the cable to a shorter length. However, you will need to strip and terminate the wires at the cut end according to your system's requirements.

The operating temperature range for this connector is from -25°C to +85°C.

Gold contact plating provides excellent conductivity and resistance to corrosion, ensuring a reliable and stable connection over time, even in challenging environments.

This cable has a current rating of 4 A, which is suitable for most standard sensor and actuator signals. It is not intended for high-power applications.

Standard M8 4-pin assignments are common. Typically, pins 1 and 2 are for signal, pin 3 for voltage, and pin 4 for ground. Always consult your sensor/actuator datasheet and control system documentation for definitive pin assignments.

The housing material is a durable polymer, designed for robustness in industrial settings.

Verify all wire connections at the unterminated end are secure and correctly mapped. Check the M8 connector for debris and ensure it's properly seated in the receptacle. Test continuity of each wire with a multimeter.

Inspect the cable for kinks or damage. Ensure the M8 connector is fully engaged and locked. Check for environmental factors (vibration, moisture) that might be affecting the connection.

Ensure you are using a standard M8 receptacle. Check both the connector and receptacle for bent pins or damaged threads. Clean both mating surfaces.

If the damage is minor and does not expose the conductors, it may still function but should be monitored. For significant damage, the cable should be replaced to maintain its environmental protection rating.