Vittoria Pit Stop Road Racing - 75ml

The foam acts as a temporary sealant and remains liquid inside the tire for up to 3 months. It is recommended to seek a permanent repair as soon as possible.

This specific 75ml version is designed for high-pressure road tires. While it may provide some inflation and sealing for wider tires, it's not optimized for the volume and lower pressures of mountain bike tires.

The foam is designed to be safe for latex, butyl, and tubeless tire systems. It is not intended to cause damage to standard road bike tires or rims.

It can inflate a 23mm road tire to approximately 6 bar (87 psi).

For large cuts or sidewall damage, the Pit Stop may not be able to seal the puncture effectively or inflate the tire. It is best suited for smaller punctures like those caused by thorns or small debris.

Dispose of the empty pressurized can according to local regulations for aerosol waste. Do not puncture or incinerate the can.

The Pit Stop is designed to seal and inflate existing chambers (tubes or tubeless setups). It cannot replace a completely destroyed inner tube.

Ensure the nozzle is securely attached to the valve stem. Check if the valve core is allowing air/foam to pass. Shake the can vigorously again.

The puncture may be too large for the 75ml cartridge to fully inflate the tire. Ensure the valve is not blocked. A second cartridge might be needed for larger tires or significant leaks.

The puncture may not have sealed completely. Spin the wheel to help distribute the foam. For persistent leaks, a more permanent repair may be required.

Carefully remove the cartridge and gently try to clear the valve with a thin wire or pin. Be cautious not to damage the valve.