Drill Mixer Paddle - 600mm x 100mm
Best current price£8.45from eBay
Best offers
Shopping.co.uk recommended and popular offers
eBay£8.45Visit shop 600mm Drill Mixer Paddle For Mixing, Paint, Plaster, Cement
Visit shopeBay£8.45Visit shop All Offers
3 offers from £8.45 - £9.99
View price history by clicking the chart icon.
eBay600mm Drill Mixer Paddle For Mixing, Paint, Plaster, Cement
Free delivery in 1–3 days
£8.45
Visit shop
600mm Drill Mixer Paddle For Mixing, Paint, Plaster, CementFree delivery in 1–3 days£9.99Visit shop →
Paint Stirrer 100mm Paddle 600mm Hex Steel Shaft for 3/8in Drill ChuckFree delivery in 1–3 days£9.99Visit shop →
Product Information
Full details
The Neilsen Drill Mixer Paddle is an essential tool for DIY enthusiasts and trade professionals needing to blend paint, plaster, and cement consistently. Designed for use with standard electric drills, it provides high-efficiency mixing capabilities through its robust steel construction, though it requires a power drill with a minimum 3/8-inch chuck capacity to operate safely and effectively.
All features
| Model Part Number | CT1173 |
|---|---|
| Brand | Neilsen |
Extended Product Information
FAQs
Can I use this with an impact driver?
No, this paddle is designed for standard drill chucks. Impact drivers generate high-torque pulses that can damage the paddle shaft or the drill coupling.
What is the maximum speed I should use?
The paddle is rated for a maximum of 900rpm. Operating above this speed may cause instability and premature wear.
Is this suitable for mixing concrete?
It is suitable for thinner mortars or plaster. For heavy-duty concrete with aggregate, a dedicated heavy-duty mechanical mixer is recommended.
How do I remove dried cement from the paddle?
If material has hardened, soak the head in water to soften it, then use a stiff wire brush to chip away the residue.
Will this fit a standard 10mm drill chuck?
Yes, as long as your drill has a 3/8-inch (approx. 10mm) chuck capacity, it will fit securely.
Troubleshooting
The paddle slips inside the drill chuck
Ensure the chuck is fully tightened and that you are using a drill with at least a 3/8-inch capacity chuck; tighten the chuck on the flat sides of the hex shaft for better grip.
Drill motor gets hot during use
The mixture may be too thick or the batch size too large. Add more water to thin the mixture, or reduce the amount of material being mixed at one time.
Material splashing out of the bucket
Reduce the drill speed and ensure the paddle is fully submerged before starting the drill. Use a bucket with a slightly higher rim if necessary.
Pros and Cons
Pros
- Durable steel design prevents bending under load
- Large 600mm reach is ideal for deep buckets
- Easy to clean if rinsed immediately after use
- Fits standard 3/8-inch or larger drill chucks
Cons
- Not suitable for use with impact drivers
- Requires significant drill torque for heavy cement mixes
- Large size can be difficult to store in small toolboxes
Setup, Compatibility & Care
To set up the paddle, ensure your drill is set to the 'drill' setting (non-hammer mode) and firmly tighten the chuck onto the hex shaft. Compatibility is straightforward: the tool works with any electric or cordless drill featuring a 3/8-inch chuck or larger.
Care instructions are critical for the longevity of the tool: always clean the paddle immediately after use. If plaster or cement dries on the steel blades, it can be extremely difficult to remove. Simply submerge the paddle head in a bucket of water and run the drill briefly to flush out residues. For stubborn dried material, a wire brush may be required.