Best current price£170.40from Bradfords
Shopping.co.uk recommended and popular offers
Bradfords£170.40Visit shop Hyco Rho Instantaneous Inline Water Heater 6.0kW for Single Hand Basin
Visit shop
B&Q£202.67Visit shop B&Q - Rho 6Kw Instantaneous Inline Thermostatically Controlled Water Heater In60T
Visit shop2 offers from £170.40 - £202.67
View price history by clicking the chart icon.
The Hyco Rho 6 kW Instantaneous Inline Water Heater (IN60TA) is designed for users needing hot water on demand for single-point applications like basins. Its key benefit is energy saving through heating water only when required, with a compact form factor for discreet under-sink installation. A key caveat is its non-thermostatic nature, making it incompatible with thermostatic mixing valves or single lever mixer taps. It features a bare wire heating system for rapid heating and is suitable for spray head taps with a maximum flow rate of 3.4 liters per minute.
| Model Part Number | IN60 |
|---|---|
| Brand | Hyco |
The Hyco Rho 6 kW IN60TA is designed to work optimally with spray head taps up to a maximum flow rate of 3.4 liters per minute.
No, this model is not suitable for showers or any application requiring a flow rate higher than 3.4 l/m. It is intended for single-point applications like basins.
Yes, this 6 kW unit requires a dedicated electrical circuit, typically a 32 Amp supply, installed by a qualified electrician.
Please refer to the manufacturer's documentation or retailer for the specific warranty period. Typically, Hyco products come with a manufacturer's warranty.
No, this water heater is designed for indoor use only and must be protected from frost and moisture.
The temperature is primarily controlled by the flow rate from the tap. Reducing the flow rate will increase the output water temperature, and increasing the flow rate will decrease it, within the unit's heating capacity. This is a non-thermostatic model.
It can be suitable for a utility kitchen sink if the primary use is hand washing and the flow rate is managed. It is not recommended for tasks requiring high volumes of hot water, such as washing large dishes.
Check the power supply to the unit. Ensure the circuit breaker is not tripped and the unit is correctly wired. Verify that the water is flowing through the heater; it only operates when water is passing through.
Confirm the flow rate is at or below the maximum 3.4 l/m. Reduce the flow at the tap if necessary. Check incoming mains water temperature; colder inlet temperatures will result in lower output temperatures. Ensure the unit has not been impacted by limescale buildup (consult a qualified installer for descaling if needed).
Some gurgling or humming during operation is normal. Loud banging or rattling could indicate air in the system or a blockage. Bleed the system if necessary (refer to installation manual).
Ensure all water connections are tight and properly sealed. If the leak persists, turn off the water supply and power, and contact a qualified plumber.
Installation:
Compatibility:
Care:
