Laminate & Wood Floor Scotia Beading - Natural Oak - 18mm Scotia

Scotia beading is used to cover the expansion gap left between the edge of laminate or engineered wood flooring and the skirting board, providing a neat and professional finish.

This beading is specifically designed for laminate and engineered wood flooring. While it might be adaptable, it's best suited for the expansion gap requirements of those materials.

The recommended expansion gap for laminate flooring is typically 10mm.

Use a fine-toothed hand saw or a mitre saw for precise, clean cuts. Measure carefully before cutting to ensure a perfect fit.

The beading comes with a laminated Natural Oak finish. While it can be painted, it's generally intended to be used as is to complement wood flooring. Painting may affect the adhesion of glues or finishes.

The beading is supplied in lengths that you cut to size. You will need to measure the perimeter of your room where the flooring meets the wall to determine the total length required.

Scotia beading has a rounded profile, while Quadra or Ronda beading often has a more square or quarter-round profile. This Scotia beading has a specific rounded profile suitable for covering gaps.

Check for any debris on the skirting board or unevenness. Ensure the flooring edge is not protruding excessively. Adjust fixing points or use a stronger adhesive if necessary.

Predrill small pilot holes into the beading before inserting nails or screws to prevent splitting. Use finer gauge fixings if possible.

The Scotia may not be correctly positioned. Ensure it is pushed firmly against the skirting board. If the gap is larger than the beading can cover, consider a wider profile beading or alternative trim.

Ensure both surfaces are clean, dry, and free from dust or grease. Use a high-strength grab adhesive specifically designed for flooring trims and wood. Allow adequate drying time as per the adhesive manufacturer's instructions.