Hot Melt Glue Sticks - 11.2mm x 200mm
Not Available
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later.
Product Information
Full details
These premium 11.2mm x 200mm hot melt glue sticks are designed for crafters, DIY enthusiasts, and homeowners seeking a versatile adhesive solution for general repairs and creative projects. They offer a strong, reliable, and smooth-melting bond across a variety of surfaces like wood, plastic, and ceramics; however, users should be mindful that they are intended specifically for standard full-size 11.2mm glue guns and may not be compatible with low-temperature or mini-size applicators.
All features
| Model Part Number | D 11.2mm X L 200mm |
|---|---|
| Brand | B2C |
Extended Product Information
FAQs
Can I use these with a mini glue gun?
No, these are 11.2mm sticks designed for full-size glue guns. They will not fit into the smaller 7mm chambers of mini glue guns.
Are these sticks waterproof?
They are water-resistant but not recommended for long-term submersion or high-moisture environments.
How long does it take for the glue to set?
The glue begins to set within seconds and reaches full strength in approximately 1-2 minutes depending on the ambient temperature.
Can I use this for electronics?
While it can be used for general cable management, it is not an electrical insulator and should not be used on exposed circuit boards or high-heat components.
How do I remove excess glue?
Once cooled, excess glue can often be carefully peeled off smooth surfaces. For residues on fabric, isopropyl alcohol can sometimes help loosen the bond.
What is the melting temperature of these sticks?
These sticks are designed for use in standard hot glue guns which typically operate between 160°C and 190°C.
Troubleshooting
Glue is too thick or stringy when dispensing
The glue gun may not be reaching the optimal melting temperature. Allow the gun to heat for an additional 2-3 minutes.
Glue stick does not advance when trigger is pulled
Check if the glue stick diameter matches your gun. If it is the correct size, ensure the glue stick is pushed fully into the heating chamber.
Bond fails to hold on smooth plastic surfaces
Lightly sand the plastic surface with fine-grit sandpaper to create a texture for the glue to anchor onto.
Pros and Cons
Pros
- Excellent adhesion on a wide range of surfaces
- Melts cleanly and consistently
- Fits most standard full-size 11.2mm glue guns
- Durable and reliable bond for various repairs
- Good value for volume
Cons
- Not compatible with mini glue guns (7mm)
- May require high-temperature guns for best results
- Not suitable for heavy-duty structural metal-to-metal bonding
Setup, Compatibility & Care
To use these sticks, insert the 11.2mm end into the rear of a full-size hot melt glue gun. Allow the gun to heat up for 3-5 minutes according to its specific manufacturer instructions. Once ready, press the trigger to dispense.
Compatibility: These sticks are exclusively for 11.2mm (often labeled 0.44 inch or 7/16 inch) glue guns. Do not attempt to use them in 7mm mini-glue guns, as they will not fit.
Care: Store unused sticks in a cool, dry place away from direct sunlight to prevent premature softening or warping. Always keep the glue gun in an upright position on its stand when hot to prevent backflow into the feed mechanism.