Setup, Compatibility & Care
Before starting your project, ensure the target surface is smooth, clean, and dry. Rough or porous surfaces like raw wood may require a primer or sanding first.
Installation Steps:
- Measure the area and add 2-3 cm of extra length on each side for trimming.
- Cut the vinyl using the grid lines on the back.
- Peel back a few centimeters of the backing paper and align with the edge of the surface.
- Press firmly with a smoother, moving slowly to prevent air bubbles.
- Trim excess material with a sharp utility cutter.
Care Instructions:
- Clean the surface with a soft cloth and mild detergent.
- Avoid harsh abrasive sponges that could scratch the matt finish.
- Use a hairdryer to gently heat the material if you need to remove the film later.