Polypipe Soil 3 Way Short Boss Pipe - 110mm - White

A 3-way short boss pipe allows you to connect three pipes together in a Y-shaped configuration, typically used for branching a soil pipe run or creating a junction within a drainage system.

This fitting is designed for 110mm soil pipes and integrates best with the Polypipe PolySoil® range. Compatibility with other brands should be verified to ensure a secure seal.

The Polypipe Soil 3 Way Short Boss Pipe supports both push-fit ring seal and solvent weld installation methods, offering flexibility for different project requirements.

For push-fit, basic pipe cutting tools are needed. For solvent weld, you will need a pipe cutter, deburring tool, primer, and solvent cement, along with appropriate safety gear.

While designed for soil and vent systems, the suitability for underground burial depends on local building regulations and the overall system design. Always consult relevant codes and standards.

Push-fit relies on a rubber seal within the fitting for a watertight connection, allowing for quick assembly. Solvent weld uses a chemical process to fuse the pipe and fitting together, creating a permanent and robust joint.

The fitting can be cleaned with a damp cloth. For tougher marks, mild soap and water can be used. Avoid using abrasive cleaners or solvents on the exterior.

For push-fit, ensure the pipe is fully inserted and the seal is correctly positioned. For solvent weld, check if the joint was held for the required duration and if sufficient cement was used. Re-joint if necessary after preparing the surfaces.

Ensure the pipe end and fitting socket are clean and free of debris. For push-fit, check for obstructions. For solvent weld, ensure primer has been applied correctly.

Verify that all pipes being connected are 110mm in diameter and compatible with the fitting type. Ensure no obstructions are present within the fitting's sockets.