Laser Tools Injector Removal Tool - Vauxhall Opel MG

This tool is compatible with MG ZS (2017-2021), Vauxhall/Opel Adam (2016-2020), Astra K (2015-2019), Corsa E (2015-2020), and Mokka X (2018-2020), specifically those with 1.0L, 1.4L, or 1.5L engines matching the listed engine codes.

Yes, you will need a slide hammer with a 5/8" UNF thread, such as the Laser Part No. 5850, to operate this injector removal tool effectively.

The tool is manufactured from carbon steel with a black phosphate finish for durability and corrosion resistance. The screws are made of alloy steel.

It means this tool performs the same function and is designed to fit the same applications as the original equipment manufacturer's part number TEN00140.

No, this tool is specifically designed for petrol injectors in the listed Vauxhall, Opel, and MG models. It is not intended for diesel applications.

After each use, clean the tool with a dry cloth to remove any debris. Store it in a dry place to prevent rust or corrosion.

Verify that your vehicle model, year, and engine code are listed in the compatibility section. Ensure you are attempting to attach it to the correct 2-bolt fuel pipe mounting plate.

Confirm that your slide hammer has a 5/8" UNF thread. Ensure the threads on both the tool and the slide hammer are clean and free from debris.

Apply penetrating oil around the injector base and allow it to soak. Use steady, consistent force with the slide hammer rather than sharp jerks. Ensure the tool is firmly attached.

Discontinue use immediately. Inspect the tool for cracks or excessive wear. Replace if any damage is detected to ensure safety and effectiveness.