Asevi General Purpose Cleaner 1L Orange - Asevi - 521551-PACK

For general cleaning, add 1-2 capfuls of Asevi Floor Cleaner to a standard bucket (approximately 5-8 litres) of water. Adjust based on the level of dirtiness and desired scent intensity.

It is suitable for a wide range of hard floors such as tiles, laminate, vinyl, and sealed wood. Always test in a small, inconspicuous area first, especially on new or delicate surfaces. Avoid use on unsealed, waxed, or porous floors.

No, the Asevi Floor Cleaner is designed to dry without needing a rinse, leaving your floors clean and fresh with its pleasant orange scent.

Once the product has dried completely, the cleaned surface is generally safe. However, always keep the concentrated product bottle securely out of reach of children and pets. Do not allow pets or children to come into contact with wet floors.

For tough stains, you can apply a slightly more concentrated solution (e.g., 2 capfuls in 3-4 litres of water) directly to a clean cloth, dab the stain, let it sit for a minute or two, then gently scrub and wipe clean. Always test on an inconspicuous area first.

Yes, you can use a diluted solution in most spray mops or floor cleaning machines. Refer to your machine's manual for specific dilution recommendations, but generally, use a similar dilution ratio as for bucket cleaning.

The Asevi Floor Cleaner Orange Concentrated is formulated to eliminate dirt, grime, and tough stains, leaving floors spotless and fresh. It is primarily a cleaner, not specifically marketed as a disinfectant.

This usually indicates too much product was used. Reduce the amount of cleaner diluted in water for the next use (e.g., use 1 capful instead of 2). Also, ensure your mop is clean and well-wrung out, not oversaturated.

Increase the concentration slightly (e.g., use 2 capfuls if you were using 1). For very tough spots, apply a small amount of diluted cleaner directly to the spot with a clean cloth, let it sit for a minute, then gently scrub and wipe clean.

Ensure proper ventilation during and after cleaning to allow the scent to circulate. For a stronger scent, you can use slightly more cleaner within the recommended dilution, but do not overdo it to avoid residue. A very dirty mop or water can also mask the scent.

This cleaner is designed for effective cleaning with minimal foam, so a lack of excessive foam is normal and not an indicator of poor performance. Focus on the actual cleaning results rather than foam levels.

Ensure the floor is swept or vacuumed thoroughly before mopping to remove loose dirt and dust. Over-dilution (too much water, not enough cleaner) or using a dirty mop can also lead to dullness. Try a fresh mop head and verify correct dilution.