Best current price£22.99from B&Q
Shopping.co.uk recommended and popular offers
B&Q£22.99Visit shop - 10X 6.35mm 1/4" Stereo Male Jack Plug Solder Connector Speaker Audio Headphone Amp
Visit shop3 offers from £22.99 - £23.99
View price history by clicking the chart icon.
This pack of 10 Loops 6.35mm stereo audio connectors is designed for musicians, audio technicians, and DIY enthusiasts who need to create or repair audio cables. The key benefit is the ability to create robust, high-quality 6.35mm jack connections for instruments and equipment. A caveat is that these require soldering skills for proper installation.
| Brand | Loops |
|---|
These are stereo connectors, indicated by the presence of three solder terminals (tip, ring, and sleeve) for left channel, right channel, and ground.
These connectors are designed to accommodate audio cables with an outer diameter of up to 7mm.
Yes, you will need a soldering iron, solder, wire strippers, and ideally a multimeter for testing continuity.
Yes, they can be used for guitar cables if you are replacing a 1/4" jack and the cable is suitable for mono unbalanced audio. Ensure you wire it as a mono connection (tip and sleeve).
Nickel plating provides good durability and corrosion resistance, helping to maintain a clean electrical connection and signal integrity over time.
The product information states that mono versions are also available, though not in this specific listing.
This pack contains 10 individual 6.35mm stereo jack plug solder connectors.
Double-check solder joints for completeness and ensure no wires are touching incorrectly. Verify that the cable conductors are correctly identified (tip, ring, sleeve for stereo) and soldered to the appropriate terminals. Test the cable continuity with a multimeter.
Inspect solder joints for cold or weak connections. Ensure the cable's shielding is properly connected to the connector body. Check for any damage to the cable itself near the connector.
The cable's outer diameter might be too small for the boot, or the solder connection may not be fully secured. Ensure the cable is properly seated and soldered for a robust connection.
Setup: To install, strip the outer jacket of your audio cable, then carefully separate and tin the individual conductor wires and the shield. Pass the cable through the connector's rear boot, then solder each conductor wire to its corresponding terminal on the connector, and the shield to the connector body. Ensure a clean solder joint and no wire bridging. The connector can then be secured over the solder points.
Compatibility: These connectors are compatible with standard 6.35mm (1/4 inch) audio jacks found on most musical instruments, amplifiers, mixers, headphones, and audio interfaces. They are designed for stereo audio signals. The connectors can accommodate cables with an outer diameter up to 7mm.
Care: While these are passive connectors, care should be taken to keep the solder terminals clean and free from corrosion. Avoid excessive moisture and physical stress on the solder joints. When not in use, store cables with these connectors in a protected manner to prevent damage to the jack.
