Best current price£6.36from eBay
Shopping.co.uk recommended and popular offers
eBay£6.36Visit shop Connect Brake Hose Aluminium Washer M10 x 14.9mm x 1.5 10 Piece Set - 34128
Visit shop7 offers from £6.36 - £9.79
View price history by clicking the chart icon.
This guide is for automotive professionals and DIY enthusiasts performing brake system maintenance. The Connect Brake Hose Aluminium Washer set provides a reliable seal for M10 banjo bolts, preventing leaks and ensuring brake system integrity. A potential caveat is that these are single-use crush washers, requiring replacement after each disassembly.
| Colour | Silver |
|---|---|
| Model Part Number | 34128 |
| Brand | Connect |
No, these are crush washers and are designed to deform upon tightening to create a seal. They should be replaced with new ones each time a brake hose connection is disturbed.
M10 indicates the thread size of the banjo bolt. 14.9mm is the outer diameter of the washer, and 1.5mm is its thickness.
Yes, these aluminium washers are compatible with both steel and other metal banjo bolts as they are designed to crush and seal against the fitting.
The set includes 10 aluminium brake hose washers.
They are used at connection points where brake hoses meet components like brake calipers, wheel cylinders, or master cylinders, secured by banjo bolts.
Reusing crush washers can lead to leaks, as they lose their ability to form a tight seal after the initial compression. This can compromise brake system performance and safety.
Ensure the banjo bolt was tightened to the correct torque specification. Verify that the washer was correctly seated and that no debris was present between the washer and the mating surfaces. The washer may also have been over-crushed or not crushed enough.
Check that you are using the correct size washer and that it is seated properly. Ensure the threads on the banjo bolt and the receiving component are clean and undamaged.
Inspect all washers before use. If any washer shows signs of damage (e.g., cracks, deformities), do not use it and replace it with a new one from the set.
Setup: These washers are designed to be used with M10 banjo bolts and compatible brake hose fittings. Ensure the surfaces of the banjo fitting and the mating component (e.g., caliper, master cylinder) are clean and free from debris. Place one washer on each side of the banjo fitting around the bolt, then insert the bolt and tighten to the manufacturer's specified torque. Always use new washers for each installation.
Compatibility: Compatible with any brake hose and banjo bolt system that specifies an M10 fitting and requires crush washers of the dimensions 10mm x 14.9mm x 1.5mm.
Care: As these are single-use crush washers, they do not require ongoing care. They should be stored in a clean, dry environment until needed to prevent contamination or damage. Discard used washers properly.
