Xcel Home Solvent Weld Reducer - 56mm x 43mm
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later.
Product Information
Full details
The Xcel Home Solvent Weld Reducer is an essential component for professional plumbers and DIY enthusiasts working on UK-standard waste plumbing systems. Its primary benefit is providing a robust, leak-free transition between 56mm and 43mm piping, ensuring long-term integrity in domestic or commercial applications. A notable caveat is that this fitting requires solvent weld cement for installation, making the resulting joint permanent and not easily adjustable once cured.
All features
| Model Part Number | 5056866127554 |
|---|---|
| Brand | Xcel Home |
Extended Product Information
FAQs
Can I use this fitting on hot water supply pipes?
No, this is a waste pipe reducer and is not rated for high-pressure or high-temperature water supply lines.
Does it come with solvent cement?
No, solvent cement must be purchased separately.
Can this be used on push-fit pipes?
No, this product is specifically designed for solvent weld systems and will not create a seal on push-fit piping with rubber O-rings.
Is this suitable for outdoor use?
Yes, provided the pipework is protected from mechanical damage and is used in a standard waste water capacity.
How long do I wait before running water through the pipes?
While the bond sets quickly, it is recommended to wait at least 1-2 hours before introducing low-pressure water and 24 hours for full curing.
Troubleshooting
The pipe does not fit into the reducer
Check that the pipe is indeed 43mm and not a larger imperial or metric standard; ensure no plastic burrs remain on the pipe edge.
Small leak found after installation
The solvent weld was likely not applied evenly. If the joint has not fully cured, you may be able to apply an extra bead of solvent around the seam, otherwise, the section must be cut out and replaced.
Pros and Cons
Pros
- Creates a permanent, leak-proof seal
- High-grade, durable plastic construction
- Standardized sizing for UK plumbing compatibility
- Simple and intuitive installation process
Cons
- Requires chemical solvent cement for a secure connection
- Joints cannot be disassembled once the solvent has cured
- Requires careful preparation of pipe surfaces for best results
Setup, Compatibility & Care
To install this reducer, first ensure both pipe ends are cut square and are free from burrs using a file or sandpaper. Clean the outside of the 43mm pipe and the inside of the 56mm reducer fitting using a surface cleaner or degreaser to ensure a strong chemical bond. Apply a thin, even layer of solvent weld cement to both the pipe and the interior of the fitting. Immediately push the pipe into the reducer with a slight twisting motion to distribute the cement evenly. Hold for approximately 30 seconds to allow the bond to set. The joint will be fully cured within 24 hours. Keep the fitting away from extreme heat sources and avoid using it in systems with high-pressure water flow, as it is strictly designed for gravity-fed waste plumbing.