Brass Hosetails Barb-BSP Male Thread Joiner - 1.25" BSPM - 32mm Barb

This hosetail is made from solid brass, known for its durability and corrosion resistance.

It refers to the thread size and type. '1.25"' is the nominal size, and 'BSPM' stands for British Standard Pipe Male thread.

The barb fitting is designed to accept hoses with an internal diameter of 32mm.

While brass offers good durability, it's best suited for low to moderate pressure applications. Always ensure your hose and clamping method are rated for the system's pressure.

It is suitable for air, gas, and water. For fuel lines, it's generally acceptable for lower pressures. It may not be compatible with highly aggressive chemicals or solvents.

For the BSP thread, use PTFE tape or pipe dope. For the hose connection, use an appropriately sized hose clamp and ensure it's tightened securely.

You will need a wrench to tighten the BSP connection and a screwdriver or nut driver for the hose clamp. Ensure the hose clamp is the correct type and size for your hose.

Ensure thread sealant tape (PTFE) or pipe dope was applied correctly. Re-tighten the connection gently. Check for damaged threads on either the hosetail or the port.

Verify the hose is the correct size (32mm) and fully seated on the barb. Ensure the hose clamp is tightened securely and appropriately sized for the hose.

Confirm the port is a 1.25" BSP male thread. Ensure threads are clean and free of debris. Do not force the connection; check for cross-threading.

Ensure you are using a 32mm internal diameter hose. The hose material may be too stiff; warming the hose end slightly (using warm water, not heat) can sometimes help. Check if the barb is obstructed.