Octogrip Cut Safety Pro Gloves - Nitrile Palm - Cut Level E / 5 - XL

This refers to the glove's resistance to cuts according to industry standards. Level E (EN388) and Level 5 (ANSI-ISEA) indicate a high level of protection against sharp objects, determined by specific testing methods like the TDM blade test.

The nitrile palm offers some resistance to water and minor spills, but the knit liner is not waterproof. They are designed primarily for cut protection and moisture-wicking from the hand, not for immersion in liquids.

These gloves are not designed for high-heat applications like welding. They offer cut protection but lack the thermal resistance required for welding tasks.

Measure the circumference of your palm at its widest point, excluding the thumb. Compare this measurement to the sizing guide provided by Octogrip to find the best fit.

Glove lifespan depends on usage frequency and intensity. Inspect gloves regularly for signs of wear, tears, or loss of cut resistance. Replace them immediately if damaged or significantly worn.

Yes, PalmWick technology is designed to wick away moisture and sweat, improving comfort even in hot conditions by keeping hands drier. However, the gloves themselves do not provide active cooling.

Ensure you have selected the correct size. Refer to the sizing chart if available. A proper fit is crucial for both comfort and protection.

Clean the nitrile palm with a damp cloth and allow to air dry. Oils and debris can reduce grip over time.

Minor fraying on the knit liner is normal. If major seams are coming apart, discontinue use as protection may be compromised.