Bosch Brad Point Drill Bit - Wood - 4mm

The Bosch Brad Point Drill Bit - Wood - 4mm is designed for use on both softwoods and hardwoods.

No, this drill bit is specifically designed for wood. Using it on metal or masonry will likely damage the bit and may not yield desired results.

It is generally recommended to use a slower drill speed, especially when drilling into hardwoods, to ensure clean and precise holes.

Make sure you start with the drill bit perpendicular to the wood surface, and maintain a steady and even pressure during drilling.

After each use, remove any wood chips or debris from the flutes of the drill bit using a brush or cloth.

The shank diameter is 4 mm.

The length of the drill bit is 75 mm.

Ensure the drill bit is centered properly on the work piece before starting. Apply firm, steady pressure, and use a slower drill speed to allow the brad point to establish the hole accurately.

Check your drill speed; using too high a speed can cause splintering. Make sure the bit is sharp. Also, use a backer board when drilling through the other side of the wood.

Stop drilling immediately. Try reversing the drill to remove the bit. If that doesn't work, carefully use pliers to extract the bit, but be cautious not to damage it or the wood.