Best current price£1.10from Professional Building Supplies
Shopping.co.uk recommended and popular offers
Professional Building Supplies£1.10Visit shop Floplast Black Solvent Weld Waste Bend - 135 Degree X 32Mm
Visit shop
The Range£5.22Visit shop Floplast Abs Solvent Weld 135' Obtuse Bend 32Mm Black - Grey
Visit shop8 offers from £1.10 - £9.07
View price history by clicking the chart icon.
The FloPlast Solvent Weld 135-Degree Obtuse Bend 32mm is designed for professional plumbers and DIY enthusiasts needing a permanent, leak-proof directional change in 32mm waste pipe systems. Its primary benefit is the solvent-weld connection, which creates a fused, airtight seal for long-term reliability in domestic or commercial settings, though users should note that the installation is permanent and cannot be disassembled once the solvent cures.
| Model Part Number | 1265490 |
|---|---|
| Brand | FloPlast |
No, this is a solvent weld fitting and is only designed to work with compatible solvent weld pipe systems.
Yes, the material is UV-stable, making it suitable for exterior waste pipe runs.
It is specifically sized for 32mm waste pipe.
While the joint will feel set within minutes, it is best to allow at least 24 hours for a full chemical cure before putting the system under load.
Because solvent welding fuses the plastic together, the joint is permanent. You would need to cut the pipe to remove the fitting.
Check if sufficient solvent cement was applied. If a gap exists, the fitting may need to be cut out and replaced.
Ensure the pipe end is deburred and cleaned of any residual plastic shavings from the cutting process.
Work in cooler temperatures if possible and ensure you twist the fitting immediately upon insertion to align it before the cement grabs.
To install this fitting, ensure the 32mm pipe ends are clean, dry, and free of burrs. Apply an appropriate solvent weld cement to the outside of the pipe and the inside of the fitting socket. Quickly push the pipe into the fitting and give it a slight twist to distribute the adhesive.
Compatibility is limited to 32mm solvent weld waste systems; it is not compatible with push-fit systems. For care, simply inspect the joints periodically for signs of stress. Because the bond is chemical, no tightening or maintenance is required after the initial 24-hour curing period.
