Polyvine Exterior Wood Varnish - Satin - 100Ml

Polyvine Exterior Wood Varnish is suitable for both exterior softwood and hardwood timber applications, including doors, windows, and garden furniture.

To achieve a fully protected dead flat finish, apply three coats of the satin varnish first, followed by a final coat of the dead flat varnish.

Yes, the varnish is waterproof and also microporous, offering protection against the elements while allowing the wood to breathe.

Clean treated wood surfaces with a damp cloth. Avoid using abrasive cleaners.

Application is best between 10°C and 25°C. Drying times will be significantly extended in cold or humid conditions.

Microporous means the finish allows moisture vapor to escape from the wood, preventing trapped moisture that could lead to blistering or cracking, while still repelling liquid water.

Yes, the varnish contains biocides which actively protect the wood against algae, mildew, and fungal attack.

Ensure the varnish is thoroughly stirred before and during application. Apply thin, even coats and maintain a wet edge to avoid lap marks. Check that the brush or roller is distributing the product evenly.

Drying times are dependent on temperature and humidity. Ensure application is within recommended environmental conditions. Lower temperatures or high humidity will increase drying time. Ensure adequate ventilation.

This may indicate moisture trapped beneath the film or inadequate surface preparation. Ensure the wood is completely dry before application and that the surface is free from contaminants. Re-apply after thorough surface preparation.

The dead flat finish requires a specific application order. Ensure at least three coats of satin varnish were applied before the final dead flat coat. Re-coat if necessary, following the correct layering procedure.