Mini rotule pivotante à 360 degrés pour appareil photo - Andoer
Not Available
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later.
Product Information
Full details
The Andoer Mini Tripod Ball Head is designed for travel photographers and content creators who need a lightweight, versatile mounting solution for cameras and accessories. Its primary benefit is the ability to achieve smooth 360-degree panoramic rotation and quick orientation shifts in a compact, pocket-sized form factor, though users should note it is intended for lighter setups weighing under 2kg.
All features
| Brand | Andoer |
|---|
Extended Product Information
FAQs
Can I use this with a smartphone?
Yes, provided you have a 1/4-inch tripod adapter for your smartphone, this ball head will work perfectly.
Is this compatible with standard tripods?
Yes, it uses the industry-standard 1/4-inch mounting thread found on almost all consumer tripods and monopods.
What is the maximum weight capacity?
This ball head is rated to support equipment weighing up to 2 kg (approximately 4.4 lbs).
Does it include a quick-release plate?
No, this model uses a direct screw-mount system for maximum compactness.
Can I mount a small LED light on this?
Absolutely, the 1/4-inch screw is ideal for mounting small light panels or microphones.
Troubleshooting
The ball head slips under the weight of the camera.
Ensure the locking knob is fully tightened. Verify that your camera and lens combination does not exceed the 2kg load limit.
Panning movement feels jerky or stiff.
Check if the base mounting is too tight against the tripod platform. Loosening the connection slightly can allow for smoother rotation.
Pros and Cons
Pros
- Extremely portable and lightweight design
- Easy switching between portrait and landscape modes
- Smooth panning movement for consistent panoramic shots
- Standardized mounting hardware compatible with most gear
Cons
- Not suitable for heavy professional DSLR rigs over 2kg
- Small locking knobs may be difficult to grip while wearing gloves
- Lacks a dedicated spirit level for leveling shots
Setup, Compatibility & Care
- Installation: Screw the ball head onto your tripod or monopod via the base thread. Once tightened, mount your camera using the top 1/4-inch screw.
- Adjustments: Use the side locking knob to loosen the ball for positioning. Once the desired angle is reached, rotate the knob clockwise to secure it.
- Orientation: To tilt the camera 90 degrees, drop the ball joint into the U-shaped notch and tighten to lock.
- Care: Keep the ball joint clean and free of sand or grit to ensure smooth movement. Do not use chemical lubricants, as these can attract dust. If it gets dirty, wipe with a dry microfiber cloth.