Proclad Aquabord PVC Tongue and Groove Shower Panel - Sandstone

Yes, Proclad Aquabord panels are specifically designed for use in shower cubicles and other wet areas due to their 100% waterproof nature.

No, unlike tiles, these panels do not require grout. The tongue and groove system creates a seamless, waterproof joint.

While it's generally recommended to install on a flat, sound substrate, minor imperfections in existing tiles might be covered. However, the wall must be structurally sound, and any loose tiles should be removed and the area made good.

Basic DIY tools are generally sufficient, including a tape measure, pencil, spirit level, fine-toothed saw or jigsaw for cutting, and a caulking gun for the adhesive.

The panels are 10 mm thick.

The panels feature a matte finish designed to mimic the look and feel of real sandstone.

These panels are designed for walls in wet areas. While they are lightweight, their suitability for ceilings would depend on the specific ceiling structure and fixing method, and they are not explicitly marketed for ceiling applications.

Ensure no debris is present in the tongue and groove channels. Check for any warping or damage to the edges. Ensure panels are aligned correctly before attempting to push them together.

Verify the wall surface is clean, dry, and free from dust or grease. Ensure the correct type and amount of adhesive specified for PVC panels is used and applied evenly. Follow the adhesive's curing time recommendations.

Check that the tongue and groove joints are fully engaged. For extra assurance in critical areas, a suitable waterproof sealant can be applied within the groove before joining, though the design aims to prevent this.

Use a non-abrasive cleaner and a soft cloth. For minor scratches, a plastic polish may be effective. Avoid using sharp objects near the panels.