NIVEA Luminous 630 Post-Acne Marks Skin Perfecting Serum 30ml - NIVEA Luminous 630

Post-acne marks are the discolored spots or patches (red, brown, or purple) that remain on the skin after an acne breakout has healed. This serum is formulated with Luminous 630 to target these marks, helping to reduce their visibility and promote a more even and perfected skin tone.

For optimal results, apply the serum twice daily – once in the morning and once in the evening – as part of your regular skincare routine.

While generally well-tolerated, individuals with sensitive skin should perform a patch test on a small, inconspicuous area before full facial application. Discontinue use if any irritation occurs.

Results can vary between individuals, but with consistent twice-daily use, visible improvements in post-acne marks typically become noticeable after several weeks to a few months. Patience and regularity are key.

Yes, this serum is designed to complement and be safely integrated with other products from the NIVEA Luminous 630 range, such as day creams or night creams, for a comprehensive approach to skin tone correction.

No, this serum is specifically formulated to address *post-acne marks* and hyperpigmentation left behind by healed blemishes. It is not intended to treat active acne breakouts. For active acne, consider products specifically designed for that purpose.

Luminous 630 is NIVEA's patented ingredient that works at a cellular level to rebalance pigmentation, helping to reduce the appearance of dark spots and prevent new ones from forming. It's the key active in this serum for tackling post-acne marks.

Ensure consistent daily application, morning and evening. Skin renewal and mark reduction take time; typically, several weeks to months of continuous use are needed to observe significant results.

Discontinue use immediately. If irritation persists, consult a dermatologist. Perform a patch test on a small area of skin before full facial application if you have sensitive skin.

Ensure your skin is clean and dry before application. Use only a small amount (1-2 pumps) and allow it to fully absorb before applying other products. Applying too much can lead to stickiness.

Ensure the cap is fully removed and try priming the pump by pressing it several times until product appears. If still not dispensing, gently tap the bottom of the bottle on a hard surface to dislodge any air bubbles, then try pumping again.