NGK Lambda Oxygen Sensor - 5714
Not Available
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later.
Product Information
Full details
The NGK Lambda Oxygen Sensor 5714 is designed for automotive enthusiasts and mechanics looking to restore precise air-fuel ratio monitoring and engine efficiency in their vehicles. By providing high-quality, reliable exhaust gas analysis, this sensor helps improve fuel economy and reduce harmful emissions, though it requires precise installation to ensure compatibility with specific vehicle electronic systems.
All features
| Model Part Number | 5714 |
|---|---|
| Brand | NGK |
Extended Product Information
FAQs
How do I know if this sensor fits my car?
Verify compatibility by checking your vehicle's service manual or using the part number OZA660-EE18 against your specific make and model.
Do I need special tools to install this sensor?
It is recommended to use an oxygen sensor socket, which allows you to fit the wire through the socket side to secure the hex nut without damaging the sensor.
Can I touch the tip of the sensor?
No, you should never touch the ceramic sensing element with bare fingers, as oils can cause the sensor to malfunction.
Does this sensor come pre-lubricated?
Check the threads on the new unit; if they appear dry, apply a light coat of high-temperature anti-seize, being careful not to get any on the sensor head.
What is the primary function of the 4-wire setup?
The 4-wire design typically includes two wires for the sensor signal and two for the internal heater, which helps the sensor reach operating temperature faster.
Troubleshooting
Check Engine light remains illuminated after installation
Clear the diagnostic trouble codes (DTC) using an OBD-II scanner after the new sensor is installed.
Sensor signal is inconsistent
Check the 4-wire harness connector for corrosion, loose pins, or damaged wiring that may prevent a solid signal.
Pros and Cons
Pros
- Meets or exceeds original equipment manufacturer standards
- High-quality, reliable construction for long-term durability
- Direct fit replacement simplifies the installation process
- Optimizes fuel efficiency through accurate exhaust analysis
Cons
- Specific to OZA660-EE18 application models
- Requires professional tools to remove existing sensors
- Sensitive electrical component prone to damage if mishandled
Setup, Compatibility & Care
Before installation, verify compatibility by matching your vehicle’s engine requirements with part number OZA660-EE18. When installing, ensure the engine is completely cool to prevent personal injury. Use an oxygen sensor socket to gently remove the old unit, and apply a small amount of anti-seize compound to the new threads if one is not pre-applied. Do not contaminate the tip of the sensor with grease or oil. Ensure the 350 mm lead is properly routed away from hot exhaust manifolds using clips to prevent melting.