Everbuild Showerproof Bathroom Silicone Sealant - White

The sealant develops a skin in approximately 15 minutes. It cures at a rate of about 2mm per 24 hours. For full watertightness, allow at least 24 hours, longer for thicker beads.

This sealant is not designed to be painted over. For a paintable finish, a different type of sealant would be required.

Avoid using on porous surfaces like untreated wood, plaster, or concrete. It is best suited for non-porous materials such as ceramics, glass, PVC, and metal.

Carefully cut away the old sealant using a sharp knife or sealant removal tool. Residual amounts can often be softened with silicone remover products before wiping clean.

Yes, this sealant is suitable for exterior applications on non-porous materials where weather resistance is needed.

A high modulus formula generally means the sealant is stiffer when cured, providing stronger adhesion and holding its shape well, making it ideal for structural sealing applications in bathrooms.

Each cartridge contains 280ml of sealant.

Ensure the surface is thoroughly clean, dry, and free from any grease, soap residue, or old sealant. Poor adhesion is often due to inadequate surface preparation.

Tool the sealant bead within 15 minutes of application using a wet finger or a dedicated tooling tool. Excess sealant should be removed promptly.

Ensure adequate ventilation and maintain a suitable ambient temperature (typically between 5°C and 30°C). Thicker beads will also take longer to cure; aim for a bead depth no greater than its width.

While formulated with anti-mould agents, persistent mould may indicate recurring excessive moisture or poor ventilation. Improve air circulation in the area and ensure the sealant is fully cured and intact.