Setup, Compatibility & Care
To install, start by stripping back approximately 10-12mm of the outer cable jacket to expose the braid, then fold the braid back over the jacket. Trim the foil shield to reveal the dielectric and inner copper conductor. Firmly twist the connector onto the prepared cable end until it feels secure and the center wire protrudes slightly from the front of the connector.
- Compatibility: Specifically for RG6 coaxial cables only.
- Care: Keep the threads clean of dust and debris to maintain a solid electrical ground. If you notice signal degradation after several months, check the connector for oxidation or looseness and re-tighten if necessary. Avoid bending the cable sharply at the connector exit point to prevent internal wire breakage.