PlastiKote Multi-Purpose Enamel - Gloss Grey

It is designed for use on a wide range of surfaces including wood, metal, plastic, masonry, and more.

The paint is touch dry in approximately 20 to 30 minutes and fully dry in about an hour. Drying times can vary based on temperature, humidity, and application thickness.

One 400ml can covers approximately 2.23m² (24 sq ft), depending on the surface and application method.

Yes, the paint is suitable for both interior and exterior projects and offers resistance to UV light and corrosion.

The paint has a heat resistance of up to 121°C (250°F).

Ensure the plastic surface is clean and dry. Lightly abrading the surface can improve adhesion. It's recommended to test on a small, inconspicuous area first.

After use, turn the can upside down and spray for a few seconds to clear the nozzle. If it remains clogged, try removing it and soaking it in a solvent. If unsuccessful, a replacement nozzle might be necessary.

Shake the can more vigorously and ensure the nozzle is clear. Turn the can upside down and spray briefly to clear the nozzle. If the problem persists, the nozzle may be blocked and may need replacement or the can may be faulty.

The spray can is likely too close to the surface, or too much paint is being applied in one go. Hold the can further away and apply thinner, more even coats. Ensure consistent motion while spraying.

The surface may not have been properly prepared. Ensure it was clean, dry, and free of grease or loose material. Light sanding of glossy surfaces can improve adhesion. Ensure the correct primer was used if required for the substrate.

Always turn the can upside down after use and spray for a few seconds to clear the propellant. If the nozzle is completely blocked, try carefully removing it and soaking it in a suitable solvent (e.g., acetone), then rinse and reattach. If unsuccessful, a replacement nozzle may be needed.