Setup, Compatibility & Care
Installation of the E-W001MB waste is straightforward for those with basic plumbing knowledge.
- Preparation: Ensure the old basin waste is removed and the drain hole is cleaned of any residual sealant.
- Installation: Insert the waste body through the basin hole from above. Apply a suitable waterproof silicone sealant around the flange if required by your basin type.
- Tightening: From underneath the basin, use a basin wrench to tighten the nut, ensuring the rubber washer creates a watertight seal against the underside of the ceramic.
- Care: To maintain the matt black finish, clean only with a soft damp cloth and mild soapy water. Never use abrasive cleaners, bleach, or acidic descaling agents, as these will damage the finish.
This unit is compatible with any sink featuring a standard 1 1/4 inch waste connection and an overflow.