Laser Tools Back Probes 8 Piece Set - 6544

This set is ideal for back probing common automotive sensors such as Manifold Absolute Pressure (MAP) sensors, Throttle Position Sensors (TPS), and fuel injectors.

The back probes have sockets designed to accept standard 4mm banana plugs from your diagnostic test leads.

The probes are designed for electrical connection; ensure you only connect to the intended terminals and avoid accidental contact with other components.

The set includes 8 probes: 2 yellow, 2 green, 2 red, and 2 blue.

No, these probes are specifically designed to interface with 4mm banana connectors. Adapters may be required for other lead types.

These probes are intended for low-voltage signal testing and diagnostics. They are not designed for high-current applications.

Wipe them clean with a dry or slightly damp cloth after use. They are resistant to automotive solvents but should not be submerged.

Ensure the probe is fully inserted into the connector and that your banana lead is firmly connected to the probe's socket. Check for any debris in the connector or on the probe.

Verify that the correct probe is used for the intended sensor and that the probe is making good contact with the wire terminal inside the connector. Ensure your test leads are functioning correctly.

While solvent-resistant, prolonged or extreme exposure may affect materials. Inspect for any swelling or degradation. Clean thoroughly and test for functionality. Replace if compromised.