Stirling Metal Scroll Garden Gate - 914mm Gap x 914mm High - Black

The given width (914mm) indicates the post-to-post gap the gate is designed for. The gate itself is physically smaller than this gap to accommodate the hinges and latch mechanism.

No, screws are not included with the gate. You will need to provide your own screws for installation.

Annual maintenance is recommended. Inspect for any scratches or chips in the coating and touch up as needed to prevent rust. Clean with a damp cloth.

The gate is electro-galvanised for rust resistance and powder-coated, but this is not a 100% rust-proof guarantee. If the coating is scratched or chipped, rust may appear and should be addressed promptly.

Yes, a made-to-measure service is available for the Stirling range. Please contact us for details on custom sizing.

The gate is constructed from solid metal with 25mm x 10mm frames and 12mm infill bars.

The gate comes with adjustable I-bolt type hinges, which allow for easier fitting and alignment.

Adjust the I-bolt hinges. Loosen the nuts, reposition the hinge, and re-tighten. Ensure posts are plumb.

Check alignment of the latch strike plate on the post and the latch on the gate. Adjust post or gate position slightly if necessary, or reposition the strike plate.

Clean the rusted area down to bare metal. Apply a rust inhibitor primer, followed by a black metal paint matching the original finish. Address any scratches or chips promptly to prevent future rust.

Check the hinges for debris or corrosion. Lubricate the hinge points if necessary. Ensure the gate is not binding against the posts or ground.