Best current price£32.06from The Range
Shopping.co.uk recommended and popular offers
The Range£32.06Visit shop Floplast Cast Iron Effect 68Mm Round 92 Degree Offset Bend - Rb8 - Ideal For Downpipe Systems - Grey
Visit shop5 offers from £32.06 - £34.71
View price history by clicking the chart icon.
This guide is for homeowners and builders working with FloPlast guttering systems. The key benefit is its ability to neatly transition downpipes from vertical to horizontal, especially useful under wide soffits, ensuring efficient water runoff. A potential caveat is its specific 92.5-degree angle, which may not suit all installations. This decorative fitting helps manage rainwater flow while maintaining aesthetic appeal in your downpipe system.
| Brand | FloPlast |
|---|
The 92.5-degree angle provides a slight fall, which encourages rainwater to run away more effectively, preventing water from sitting in the pipe and reducing the risk of blockages or freezing damage compared to a flat 90-degree bend.
No, this bend is specifically designed for FloPlast 68mm round downpipe systems only and is not compatible with square downpipes.
Clean the bend with a damp cloth and mild soap if needed. Avoid abrasive cleaners. Ensure any debris is cleared from the pipe system regularly.
It allows the downpipe to run neatly below wide soffits, maintaining a more horizontal line and a cleaner appearance, rather than dropping diagonally back to the wall.
This fitting serves both functional and decorative purposes. It aids in water management while being designed to complement the overall appearance of the guttering system.
This bend is designed for 68mm round downpipes.
If the downpipe lacks a sufficient fall, water can pool, leading to potential blockages, algae growth, ice formation in winter, and increased wear on the system.
Ensure the pipe ends are clean and the bend is fully seated onto the connecting pipes. Check for any damage to the pipe ends or the bend itself. Re-secure the connection, potentially using a recommended sealant if the joint is loose.
Verify that the bend is installed with the correct orientation to allow for a downward fall. Ensure there are no obstructions or blockages further down the downpipe system.
Confirm that you are using a FloPlast 68mm round downpipe. Ensure the pipe ends are not deformed. If the fit is still too loose, consider using a pipe clip or connector designed for this purpose, following manufacturer guidelines.
Setup:
This bend is designed to connect directly to FloPlast 68mm round downpipes. Ensure the existing pipe ends are clean and free from debris before attempting to fit the bend. The bend typically slides over or into the connecting pipe sections. Secure connections firmly to prevent leaks, using appropriate methods as recommended by FloPlast (e.g., sealant or mechanical fixings if applicable).
Compatibility:
This fitting is specifically designed for use with the FloPlast 68mm round downpipe system. It is not intended for use with square downpipes or other brands unless explicitly stated by the manufacturer. Verify your existing downpipe dimensions and profile before purchase.
Care:
To maintain the appearance and function of the downpipe bend, regular cleaning is recommended. Periodically inspect for debris buildup, especially after periods of heavy rainfall or leaf fall. Clean the exterior with a damp cloth and mild detergent if necessary. Avoid abrasive cleaners that could damage the finish. Ensure that connections remain secure to prevent leaks.
