Compression Equal Tee 15mm Chrome - Flowflex - G31815CP

You will need two wrenches (e.g., adjustable wrenches or pipe wrenches) to tighten the compression nut securely. A pipe cutter and deburring tool are also recommended for preparing the copper pipe.

No, this specific fitting is designed for use with 15mm copper tubing only. Using it with other materials will likely result in leaks and connection failure.

Compression fittings like this are generally suitable for standard domestic hot and cold water temperatures, and typical central heating system temperatures. Consult the manufacturer's specifications for precise limits if operating outside normal ranges.

Tighten the nut until it is snug, then apply an additional 1/2 to 3/4 of a turn. It's crucial not to overtighten, as this can damage the pipe or fitting. If in doubt, refer to the installation instructions or consult a professional plumber.

This fitting is manufactured to BS EN1254 standards, which cover general plumbing and heating applications. For unusually high-pressure systems, confirm the specific pressure rating with the manufacturer.

Compression rings are designed to form a permanent seal and are generally not recommended for reuse once compressed onto the pipe. For best practice and to ensure a reliable seal, use a new ring for each connection.

Check that the pipe was fully inserted into the fitting. Ensure the compression nut has been tightened sufficiently (an additional 1/4 to 1/2 turn may be needed). Verify the copper pipe is not damaged or deformed and that the olive is correctly seated.

Ensure the end of the copper pipe is clean, round, and free of burrs. Use a deburring tool if necessary. Ensure no debris is inside the fitting body.

Ensure the threads on the nut and fitting are clean and free from debris. Try applying a small amount of appropriate pipe lubricant to the threads, but avoid getting any on the olive or pipe end, as this can affect the seal.