Winmau Blade 6 Dartboard Fixing Kit - X0406

This kit is specifically designed for the Winmau Blade 6 series. While it might fit other boards, compatibility is not guaranteed.

You will need a drill, a screwdriver (usually Phillips head), a tape measure, and a spirit level to ensure proper alignment.

Yes, but you will need to purchase specific masonry wall anchors if your wall type requires them, as standard wood screws may not hold.

Yes, the kit includes the essential mounting components required for the Blade 6 series.

It is recommended to check that your mounting hardware is tight every few months or whenever you notice the board shifting.

Ensure the center screw is screwed firmly into the back of the board and that the board is pulled tightly against the wall bracket.

Adjust the leveling feet or side brackets provided in the kit until the board sits perfectly parallel to the floor.