Arrma Rod End Set - 4x4

Inspect them for visible cracks, excessive play or looseness in the ball joint, or if they feel unusually stiff or sticky. If steering is imprecise or suspension feels uneven, rod ends are a common culprit.

This specific set (AR330470) is designed for Arrma 4x4 models. You must confirm compatibility with your exact vehicle model using the product's MPN and your vehicle's manual or the Arrma-RC website.

Different sets are designed for specific Arrma models and may have varying sizes, lengths, or thread pitches to match the suspension and steering geometry of those models.

Typically, you will need basic RC tools such as pliers, a small screwdriver, and potentially an Allen wrench or nut driver, depending on how the rod ends are attached to your vehicle's components.

It's recommended to inspect rod ends before each significant run or after a hard impact. Regular maintenance checks will help prevent failures during use.

It means these parts are intended as direct replacements for the rod ends that originally came assembled on, or were included as spares within, your Arrma RC car kit.

Ensure no debris is trapped in the threads or socket. Check if the rod end is cross-threaded during installation. Gently work the ball joint to loosen it.

Verify the rod end is fully seated onto the ball stud and that the retaining mechanism (if any) is secure. Ensure the correct size rod end is used for the ball stud.

Inspect all rod ends for wear or damage. Ensure all rod ends are properly tightened and that the ball joints are not excessively loose within their sockets.