VMS Flexy 5K XT Thin Model Glue 20g - CM07

The 'XT Thin' formulation allows the glue to flow easily into very fine gaps and seams through capillary action, making it ideal for intricate model building.

For best results, use a fine applicator, syringe, or apply directly from the bottle to very thin seams. The goal is controlled application to utilize its capillary action.

It is suitable for most common plastics used in model kits. However, it's always recommended to test on a small, inconspicuous area first if you are unsure about the plastic type.

While it can be used for larger parts, its thin nature means it dries quickly and may not be ideal for filling large gaps where a thicker adhesive might be preferred. It is best suited for fine detail work and seams.

The glue dries relatively quickly, allowing for faster assembly. However, the exact drying time can vary depending on the amount applied, humidity, and temperature.

When stored correctly in a cool, dry place with the cap tightly sealed, the glue should maintain its quality for an extended period. Always check for any signs of degradation before use.

Yes, once fully cured, the glue can generally be painted over or primed like the plastic it bonds. Ensure the glue is completely dry before applying any finishes.

Ensure the nozzle is not blocked. If it is, carefully clear it with a fine pin or needle. Check that the glue has not dried out in the bottle.

Work in smaller sections and apply only what is needed immediately. Ensure the ambient temperature is not excessively high.

Reduce the amount of glue applied. Use a finer applicator for more control or consider blotting excess with a cotton swab dipped in a compatible solvent.

Ensure the surfaces were clean and free of dust or grease before application. Ensure adequate glue reached the joint and was allowed to cure fully.