Best current price£7.49from OnBuy.com
Shopping.co.uk recommended and popular offers
OnBuy.com£7.49Visit shop 44Mm 46Mm Quad Bike Pod Style Air Filter Performance Thick Foam Bent Neck Black 5056499478528
Visit shop1 offer from £7.49
View price history by clicking the chart icon.
This PetrolScooter pod style air filter is designed for quad bike enthusiasts looking to enhance engine airflow and throttle response. By utilizing a high-quality thick foam element, it provides a balance between increased air intake and robust dust filtration for off-road environments. While it offers a significant performance boost over standard air boxes, users should note that installing a pod filter may require carburetor jetting adjustments to maintain a proper air-fuel ratio.
| Model Part Number | 40322-1 |
|---|---|
| Brand | PetrolScooter |
It fits carburetors with a 44mm to 46mm intake diameter. Always measure your carburetor inlet diameter before purchasing.
Yes, in most cases, installing a high-flow pod filter increases air intake significantly, which usually requires a larger main jet to prevent the engine from running too lean.
Cleaning frequency depends on your riding environment. In dusty conditions, check the filter after every few rides.
While the foam is durable, it is not waterproof. Avoid deep water crossings and consider a water-repellent pre-filter cover if riding in wet conditions.
Most filters arrive dry or with minimal factory oil. It is highly recommended to apply a high-quality foam filter oil before your first ride.
The increased airflow is likely causing a lean condition. Adjust your carburetor needle or install a larger main jet.
Ensure the clamping area is clean and free of oil residue before tightening. If it still slips, check for cracks in the rubber neck.
Verify that the filter is fully seated and that you are using an appropriate amount of filter oil to trap fine particulates.
To install, loosen the existing carburetor intake clamp and remove your old air box or filter. Slide the 44mm/46mm neck onto your carburetor inlet and tighten the clamp securely to ensure an airtight seal.
For care, periodically inspect the foam for debris. To clean, remove the filter and wash the foam with a mild detergent and water, or a dedicated foam filter cleaner. Ensure the filter is completely dry before re-oiling with high-quality foam filter oil to maximize dust-catching capabilities. Never run the engine without a properly seated filter, as even small amounts of grit can cause significant cylinder wear.
