Fluidmaster Bottom Entry Float Valve - Brass Shank 1/2in

Loosen the adjustment clip or screw (depending on the model) and slide the float up or down to set the desired water level. Tighten the clip or screw once adjusted.

You'll typically need a wrench, pliers, and possibly a screwdriver. A bucket and sponge are also helpful to clean up any spills.

If your toilet is constantly running, filling slowly, or making noise, it's a good indication the valve may need replacing.

Yes, the Fluidmaster Bottom Entry Float Valve is designed for easy installation, and many homeowners successfully install it. However, if you are uncomfortable, consult a plumber.

The Fluidmaster Bottom Entry Float Valve comes with a 5-year warranty.

Use a damp cloth to wipe down the valve. Avoid using harsh chemicals or abrasive cleaners that could damage the components.

Check for debris or obstructions in the valve. Make sure the float isn't rubbing against the tank wall. If the problem persists, the valve may need to be replaced.

Check the flapper valve for proper sealing. Also, ensure the float isn't rubbing against the tank walls. Adjust or replace parts if needed.

Check the water supply valve to make sure it's fully open. Check for sediment or blockages and clean or replace the valve as necessary.

Ensure the valve is properly installed. Tighten any loose connections. Consider installing a water hammer arrestor if the problem persists.

Check and tighten the connections. Ensure the rubber seals are in good condition and replace them if needed.