Liberon Wood Filler - Antique Pine

Liberon Wood Filler typically dries in approximately 1 hour. However, drying time can vary depending on the thickness of application, temperature, and humidity.

Yes, it can be used for exterior applications, but it must be protected with a suitable exterior-grade varnish, paint, or other weather-resistant finish for durability.

As it is water-based, tools and any excess filler can be cleaned up easily with water immediately after use.

Yes, once dry, the filler can be sanded smooth and is suitable for staining, varnishing, waxing, or painting to match your project.

It is ideal for filling and repairing surface damage like holes, gouges, cracks, and imperfections in wood. It is not designed for large structural repairs.

Yes, the filler is flexible and robust enough to be nailed or screwed into after it has fully dried.

The filler is available in natural and various wood shades. For a precise match, you can also colour it using Liberon Earth Pigments before application. Always test the colour on a small, inconspicuous area first.

Ensure the lid is tightly sealed when not in use. If slightly dried out, you may be able to reintroduce a small amount of water and mix thoroughly.

This can happen if applied too thickly in one go or if the surface was not properly prepared (e.g., dusty or greasy). For thicker applications, apply in layers, allowing each layer to dry. Ensure the surface is clean and sound.

Wood fillers, especially water-based ones, can absorb stain differently than natural wood. Test the stain on a scrap piece of wood and filler before applying to the repaired area. The filler can also be coloured using Liberon Earth Pigments for a closer match before application.

Ensure adequate ventilation during drying. If the environment is very humid, drying may take longer. Avoid applying excessive amounts of filler in a single layer, as this can impede proper drying.