Rotary Laser Kit - Laserliner

The Laserliner Cubus 210 S Set 150 cm has a maximum measurement distance of 200 meters when used with a laser receiver.

Yes, the 'Set 150 cm' designation typically indicates that a lightweight tripod, laser receiver, and measuring staff are included.

Yes, the battery pack can be used and charged simultaneously, allowing for continuous, uninterrupted operation.

The device has an IP66 rating, which means it is protected against dust ingress and powerful water jets.

The accuracy is rated at 0.15 mm, ensuring precise levelling for demanding professional tasks.

The available modes include spot, scan, rotary, and hand-held receiver mode.

The ADS Tilt function automatically shuts down the device if it detects external influences that could lead to measurement errors, ensuring reliability.

The laser beam has a wavelength of 635 nm.

Check if the laser is powered on and if the battery is sufficiently charged. Ensure the lens is clean and unobstructed. Increase ambient light sensitivity settings if available or use in lower light conditions.

Verify the battery pack is correctly installed and charged. Connect the charger and check if the charging indicator lights up. Try using the device while it's plugged in and charging.

Ensure the laser is placed on a stable, vibration-free surface or tripod. Check that the ADS Tilt function is active to prevent errors from movement. Re-calibrate the device if necessary following the manufacturer's instructions for basic setup.

Check the batteries in the remote control and replace if necessary. Ensure there are no obstructions between the remote and the laser unit. Verify you are within the 30-meter operating range.

Refer to the user manual for specific error code meanings. Common solutions include restarting the device, checking battery levels, or ensuring the unit is not exposed to extreme temperatures outside its operating range (-10 to 50 °C).