Setup, Compatibility & Care
To begin your project, gather a sharp utility knife, a felt edge smoother, and a hairdryer. Before starting, clean the target area thoroughly with a mild detergent and ensure it is fully dry.
- Measure the area and cut the film with a 2-3cm overlap.
- Peel back a small section of the backing and align the film.
- Apply steady pressure with your smoother while pulling the backing away slowly.
- Use a utility knife to trim excess material flush with the surface edge.
- For long-term care, simply wipe the surface with a soft cloth and mild soap. Avoid harsh chemical cleaners or abrasive scouring pads, as these may dull the finish or compromise the adhesive over time.