Bosch EXPERT Power Change Plus Holesaw Accessories - 7.15 x 105 mm

The EXPERT Power Change Plus system is specifically designed for use with Bosch EXPERT Tough Material and Construction Material hole saws.

The system supports a cutting depth of 60mm when used with compatible hole saws.

Users can achieve up to 5x faster results compared to older mounting systems.

No, this package includes two EXPERT Power Change Plus units with a centring drill. Compatible Bosch EXPERT hole saws need to be purchased separately.

The centring drill measures Ø7.15 x 60 x 105 mm.

While the system is designed for Bosch EXPERT hole saws, it's not recommended for use with other brands as compatibility and safety cannot be guaranteed.

Clean the unit after each use to remove dust and debris. Store it in a dry environment to prevent corrosion and ensure the release mechanism remains functional.

Ensure the arbor shaft and the Power Change Plus unit's internal mechanism are clean and free of obstructions. Verify you are using a compatible Bosch EXPERT hole saw.

Confirm the hole saw is fully engaged and has clicked into place. Check for any damage to the locking mechanism on both the arbor and the hole saw.

Ensure the centring drill is properly seated and not worn down. Check that the drilling surface is accessible for the pilot mark.

Press the release button firmly and ensure no debris is obstructing the mechanism. If stuck, a gentle tap might dislodge it, but avoid excessive force.