Setup, Compatibility & Care
Setup:
- Ensure the surface is perfectly clean, dry, and smooth.
- Measure and cut the vinyl using the grid on the reverse.
- Peel back a small section of the backing paper.
- Apply the vinyl to the surface, smoothing out air bubbles with a felt edge smoother as you go.
- For curved edges, use a hairdryer on a low setting to gently warm and stretch the vinyl.
- Trim any excess material with a utility cutter.
Compatibility:
Applies to any flat, smooth, and clean surface. This includes wood, metal, glass, and painted surfaces. Not recommended for textured, porous, or uneven surfaces.
Care:
- Wipe clean with a damp cloth.
- Wipe up spills immediately to prevent staining.
- For areas around sinks and hobs, apply a sealant along the edges to prevent water or dirt ingress.
- Avoid using abrasive cleaners or pads that could scratch the surface.
- To remove, gently heat the vinyl with a hairdryer and peel slowly.