SunPlex High Impact Bronze Polycarbonate Corrugated Roofing Sheet - 800 x 1060mm

Yes, polycarbonate sheets can be cut using a fine-toothed saw or circular saw with a blade designed for plastic.

The bronze tint is translucent; it allows soft, diffused light to pass through while providing significant shading and heat protection.

Divide the total width of your roof area by 800mm (accounting for any required overlap) to determine the number of sheets needed.

Yes, the high-quality polycarbonate material is engineered to resist UV degradation, preventing yellowing and brittleness over time.

Use hex-head roofing screws with EPDM rubber washers, driving them through the 'crown' of the corrugation to minimize leak risks.

It is not recommended, as paint will not adhere well to the polycarbonate surface and may cause the material to absorb more heat, leading to premature warping.

Ensure that sealing washers are used with each fastener and that the screws were not overtightened, which can warp the seal.

Check that the screw holes are drilled slightly larger than the screw shank to allow for natural thermal expansion of the polycarbonate.

Ensure you are using a mild, non-abrasive soap. Avoid solvent-based cleaners that can cloud the polycarbonate material.