SecureFix Direct Lifting Bow Shackle Screw Pin - 7.25 Ton

SWL stands for Safe Working Load. A 7.25 Ton SWL means the shackle is certified to safely lift and hold a maximum load of 7.25 tons (approximately 14,500 lbs). This is the maximum load the shackle should be subjected to in service.

The screw pin should be fully threaded into the shackle body until it is snug. Ensure there is no gap between the pin shoulder and the shackle eye. For critical applications, consider using thread-locking compounds or safety pins if the design allows and the application demands extra security, though standard tightening is often sufficient for BS 3032 compliant shackles.

This shackle has a safety factor of 5:1. This means it is designed to withstand loads up to five times its Safe Working Load before failure, providing a significant margin of safety.

The self-colour finish provides a basic level of protection against rust. For environments with high humidity, salt spray, or exposure to corrosive chemicals, additional protective measures or a galvanized/stainless steel shackle may be necessary.

The shackle should be inspected visually before each use. A more thorough inspection for wear, damage, and proper function should be conducted periodically, depending on the frequency and severity of use.

You will receive the 7.25 Ton Lifting Bow Shackle with a Screw Pin. A test certificate confirming its specifications and compliance will be sent via email separately.

Yes, this shackle is designed for lifting applications, including overhead lifting, provided it is used within its Safe Working Load limits and all safety standards and proper rigging practices are followed.

Clean the threads on both the pin and the shackle body. Remove any dirt, debris, or rust. Apply a small amount of appropriate lubricant to the threads before attempting to screw it in again.

Immediately remove the shackle from service. Do not use it for lifting. Contact the manufacturer or a qualified professional for inspection or replacement.

Check the threads for damage or excessive wear. Ensure the pin is the correct size for the shackle. If threads are stripped or damaged, the shackle and pin must be replaced.

Clean the affected area with a wire brush. For light rust, you can apply a suitable protective coating. For significant corrosion, especially on load-bearing surfaces, the shackle should be removed from service.