Dremel 490 Dust Collector

It is compatible with most Dremel rotary tools that use a standard collet nut, but it is not compatible with the Dremel 4200 model.

Yes, the Dremel 490 Dust Collector requires the 225-01 Flex Shaft attachment to be used.

It attaches to the threaded nose of the Dremel rotary tool, or to the end of the 225-01 Flex Shaft, and is secured with the tool's collet nut.

It is designed to blow away dust and chips generated during grinding, engraving, and carving, improving visibility.

No, the Dremel 490 Dust Collector is designed to work specifically with the 225-01 Flex Shaft attachment.

It is recommended to clean the dust collector periodically, especially after heavy use, by brushing or using compressed air to remove accumulated dust.

The dust collector blows dust away from the workpiece for better visibility. While it significantly reduces dust in the immediate work area, it does not capture all airborne dust particles.

Ensure the dust collector is securely attached to the rotary tool or flex shaft. Check for any blockages in the nozzle or internal passages and clear them with a brush or compressed air. Confirm the rotary tool is operating at a sufficient speed.

Tighten the collet nut that secures the dust collector to the rotary tool or flex shaft. Make sure you are using the correct collet for your tool and accessory.

While the dust collector improves visibility, it may not capture 100% of fine dust. Adjust the angle of the tool or your position to better direct airflow. Consider using a secondary dust collection system for very fine or hazardous dust.